480 804 1227
You Are Here: Home > Educational Equipment > Laser > Educational Lasers > Fiber Optic Rod IF ACR

Fiber Optic Rod
Low-cost acrylic aid for demonstrating optical fiber waveguide principles

A specially formulated acrylic rod for demonstrating the basics of fiber optics when used with a visible light laser. To illustrate, merely align the end of the rod at an angle and watch the laser light rays "bouncing" down the acrylic cylinder by total internal reflection. Ideal for inexpensive but dramatic demonstrations of Snell's Law in action. 15 cm in length.

  Fiber Optic Rod

Part Number: IF ACR 
Price: $8.50
Quantity





LASER CLASSIFICATIONS

All manufacturers of lasers used in the United States, must conform to regulations administered by the Center for Devices and Radiological Health (CDRH), a branch of the U.S. Department of Health and Human Services. CDRH categorizes lasers as follows:

 Class 1

A laser or laser system which does not present a hazard to skin or eyes for any wavelength or exposure time. Exposure varies with wavelength. For ultraviolet, .2 to .4m exposure is less than from .8 or near IR, the exposure is < 200w. Consult CDRH regulations for specific information.

 Class 2

Any visible laser with an output less than 1 mW of power. Warning label requirements yellow caution label stating maximum output of 1 mW. Generally used as classroom lab lasers, supermarket scanners and laser pointers.

 Class 3a

Any visible laser with an output over 1 mW of power with a maximum output of 5 mW of power. Warning label requirements red danger label stating maximum output of 5 mW. Also used as classroom lab lasers, in holography, laser pointers, leveling instruments, measuring devices and alignment equipment.

 Class 3b

Any laser with an output over 5 mW of power with a maximum output of 500 mW of power and all invisible lasers with an output up to 400 mW. Warning label requirements red danger label stating maximum output. These lasers also require a key switch for operation and a 3.5-second delay when the laser is turned on. Used in many of the same applications as the Class IIIa when more power is required.

 Class 4

Any laser with an output over 500 mW of power. Warning label requirements red danger label stating maximum output. These lasers are primarily used in industrial applications such as tooling, machining, cutting and welding. Most medical laser applications also require these high-powered lasers.