(480) 804-1227
You Are Here: Home > Educational Equipment > Laser > Educational Lasers > Scattering solution IF 850005

Scattering solution
Solution aids in viewing laser beams passing through water.

A special formulation of highly concentrated microscopic scattering particles that will enhance viewing of laser beams as they pass through water. Add small amounts of the solution to water in clear containers. Ultra-small particles remain suspended and do not disperse. 4 oz.

Non-toxic.

  Scattering solution

Part Number: IF 850005 
Price: $12.00
Quantity


For use with Industrial Fiber Optics' IF 548 and IF 549 Light Ray Viewing kits



LASER CLASSIFICATIONS

All manufacturers of lasers used in the United States, must conform to regulations administered by the Center for Devices and Radiological Health (CDRH), a branch of the U.S. Department of Health and Human Services. CDRH categorizes lasers as follows:

 Class 1

A laser or laser system which does not present a hazard to skin or eyes for any wavelength or exposure time. Exposure varies with wavelength. For ultraviolet, .2 to .4m exposure is less than from .8 or near IR, the exposure is < 200w. Consult CDRH regulations for specific information.

 Class 2

Any visible laser with an output less than 1 mW of power. Warning label requirements yellow caution label stating maximum output of 1 mW. Generally used as classroom lab lasers, supermarket scanners and laser pointers.

 Class 3a

Any visible laser with an output over 1 mW of power with a maximum output of 5 mW of power. Warning label requirements red danger label stating maximum output of 5 mW. Also used as classroom lab lasers, in holography, laser pointers, leveling instruments, measuring devices and alignment equipment.

 Class 3b

Any laser with an output over 5 mW of power with a maximum output of 500 mW of power and all invisible lasers with an output up to 400 mW. Warning label requirements red danger label stating maximum output. These lasers also require a key switch for operation and a 3.5-second delay when the laser is turned on. Used in many of the same applications as the Class IIIa when more power is required.

 Class 4

Any laser with an output over 500 mW of power. Warning label requirements red danger label stating maximum output. These lasers are primarily used in industrial applications such as tooling, machining, cutting and welding. Most medical laser applications also require these high-powered lasers.